Repair cost
Monogram surface igniter replacement cost
A defined burner repair, and one where the free check comes first: a cap that has gone back a fraction off its seat will spark forever and never light, and that costs nothing to correct.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
The short version
Where this figure comes from
A starting point for built-in appliances in South Florida, published so the number is not a mystery until somebody is standing in your kitchen.
Starts at
from $175
After a diagnostic from $95, which comes off the bill when you go ahead with the work.
or call (305) 614-3572
It is not
A quote for your unit
Exact cost
Confirmed after the on-site diagnostic
Warranty
On the labor we performed
What moves it
Why two of the same job cost different amounts
These apply at the same time and in both directions. Which of them is true of your kitchen is what the on-site diagnostic settles.
-
Whether it is the cap or the igniter
Re-seating is free. Ordering an igniter for a badly seated cap is not.
-
How many burners are affected
One burner is that burner. All of them is the module or the supply, and a different conversation.
-
Whether the switch is wet
Continuous clicking after lighting is moisture, and it often clears on its own once everything is properly dry.
-
Whether the part is a stocked item
Monogram parts are lower-volume than mass-market equivalents, so some arrive next day and some are ordered. We say which before you commit, because it decides whether this is one visit or two.
-
What the installation costs in time
A freestanding appliance is pulled out; a built-in one is not. Panels, trim and sometimes a neighboring cabinet come off in an order and go back the same way, and that time is real work rather than padding.
The work itself
What we actually do
The job behind the figure: what it involves, when a symptom points at it, and what we check first.
-
from $175 Surface igniter replacement
One burner sparks and will not light while the others are fine. Before any part is ordered there is a check that resolves a large share of these calls for nothing: the burner cap, which comes off for cleaning and goes back in an orientation that matters. A cap sitting a millimeter proud will spark forever and never light.
- Cap seating checked before anything is ordered
- Igniter, port and harness measured
- Continuous clicking is usually moisture
In more detail
About Monogram surface igniter replacement cost
The free answer first
A professional burner's cap and ring come off for cleaning and go back in an orientation that matters. A millimeter proud is enough to stop it lighting forever.
When it is a part
The igniter, the port, or the harness to it. All modest, all ordinary.
Why clicking should not be left
A spark module running continuously is not in a state it was designed for, and it is a cheaper visit before it fails.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about monogram surface igniter replacement cost
Should I try anything before booking?
Take the cap and ring off, dry everything, put them back squarely, and try again. It works more often than any part on this page.
No burner will light at all.
Then it is supply or the module rather than igniters — and if you can smell gas, leave and call the gas utility before you call us.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name