MonogramRepair Miami

Service

Monogram surface igniter replacement

One burner sparks and will not light while the others are fine. Before any part is ordered there is a check that resolves a large share of these calls for nothing: the burner cap, which comes off for cleaning and goes back in an orientation that matters. A cap sitting a millimeter proud will spark forever and never light.

  • From $95 diagnostic, credited to the repair
  • 59 cities and neighborhoods covered
  • OEM parts available on order
  • In writing the price, before anything is opened

Before you read on

What this job costs and how it is agreed

A starting figure, not a quote. What moves it is the model, how the unit is built in and which part it needs — settled after the on-site diagnostic.

Starts at

from $175

After a diagnostic from $95, which comes off the bill when you go ahead.

Diagnostic

From $95, credited to the repair

The price

In writing, before anything is opened

Warranty

On the labor we performed

On the visit

How this visit actually goes

The same order every time, so nothing is opened and nothing is charged before you have seen the figure and said yes.

  1. 01

    Re-seat the cap and ring

    Free, immediate, and the answer more often than any part on this page.

  2. 02

    Clear the port

    A blocked port gives a lazy flame or none at all, and it is cleaned rather than replaced.

  3. 03

    Test the igniter

    Spark quality and continuity, against the ones that work as a reference.

  4. 04

    Check the switch and the module

    Continuous clicking after lighting is moisture in a switch, and a spark module running constantly is not in a state it was built for.

  5. 05

    Light every burner before leaving

    Including the ones that were fine, because a module problem shows up across the top.

Applies to

  • A 48-inch professional stainless range in a dark kitchen with six burners on the left and a smooth griddle plate on the right, heavy brass-toned knobs along the front.
    30, 36 and 48-inch · dual-fuel, all-gas and induction

    Monogram range repair in Miami

    Monogram does not make an ordinary range. The line is professional: 30, 36 and 48 inches, dual-fuel with a gas top over an electric oven, all-gas throughout, or induction — with griddles and grills on the wider models. A 48-inch dual-fuel range is a gas appliance, an electric appliance and a ventilation problem in one piece of steel, and the diagnosis starts by working out which of the three is talking.

    • Dual-fuel, all-gas and induction, 30 to 48 inches
    • Griddle and grill sections are their own repair
    • The F-code family covers the oven side, not the burners
    Range repair
  • A wide induction cooktop set flush into a dark stone worktop, black glass reflecting a warm ceiling light, one heavy flat-bottomed pan standing on it.
    Deep-recessed gas · induction · 36 and 48-inch professional rangetops

    Monogram cooktop repair in Miami

    Two appliances that people describe with the same word. A cooktop drops into the counter and has nothing underneath it; a rangetop is a professional cooking surface with a finished front and a wall oven or cabinetry below. Monogram builds both — deep-recessed gas and induction cooktops in 30 and 36 inches, and 36 and 48-inch gas rangetops with griddles.

    • Gas and induction cooktops, 30 and 36 inches
    • 36 and 48-inch professional gas rangetops with griddle options
    • Induction problems are electronic and heat-related
    Cooktop repair

In more detail

About Monogram surface igniter replacement

About burners that spark and will not light

One burner clicks and will not light while the others are fine, which tells you the supply and the control are healthy and the problem is at that burner. Before any part is ordered there is a free check that resolves a large share of these calls: the burner cap, which comes off for cleaning and goes back in an orientation that matters. A cap sitting a millimeter proud will spark forever and never light.

This article is based on:

  • Official manufacturer documentation
  • Internal repair procedures
  • Technician repair history
  • Company quality standards

Before you book

Questions about monogram surface igniter replacement

Everything clicks constantly, even after a burner lights.

That is moisture or debris in a switch, and in this climate it is seasonal. Leave the caps off and give it a day to dry properly — it often settles. If it does not, it is the switch or the spark module, and it should be dealt with, because a module sparking continuously is not in a state it was designed for.

No burner will light and they all spark.

That is a different and larger question, and it is usually about supply rather than about igniters. Check that gas is reaching the house and the appliance — and if there is any smell of gas at all, stop, leave and call the gas utility before you call us.

Tell us the model number and what it is doing.

Call (305) 614-3572